Uncover the type and use of nanocrystalline magnetic core (attached figure)!

Nanocrystalline magnetic core has high permeability, high saturation magnetic induction, low coercivity and low loss. Suitable for EMC/EMI filter common mode inductor, high frequency transformer, frequency converter, current transformer and other occasions. In the field of new energy, such as solar inverter, wind power generation and other occasions has also been widely used.

Nanocrystalline magnetic sheet, mobile phone wireless charger magnetic sheet, communication equipment shield sheet, ultra-thin amorphous nanocrystalline shield magnetic sheet

Nanocrystalline magnetic sheets have very high permeability. Mainly used for mobile phone wireless charging receiver, shielding electromagnetic interference to mobile phone, reduce energy loss, improve charging efficiency. It can also be used in other areas of wireless charging, such as car wireless chargers. The thinest thickness of nanocrystalline magnetic sheet can reach 0.1mm, and the thickness can also be increased to obtain higher performance. Various sizes and shapes can be customized according to customer requirements.

Nanocrystalline core for common mode inductors, high permeability, used for EMC common mode inductors, EMI filters

The nanocrystalline core has very high permeability, wide frequency characteristics, and still has high permeability until the high frequency of 30MHz. Very suitable for EMC filters, common-mode inductors to suppress common-mode noise. Compared with traditional soft magnetic materials, such as ferrite magnetic core, nanocrystal magnetic core has obvious advantages, high inductance, good filtering effect, small size, fewer turns of copper wire, high efficiency and energy saving.

Nanocrystalline cores for high-frequency transformers

Epoxy-coated nanocrystalline magnetic cores are smaller than boxed magnetic cores, require less copper wire, lower copper loss, reduce cost, save energy and save space. Applicable to micro filter common mode inductors, ISDN network transformers, network filters, EMC filters, IGBT/Mosfet drive transformers, HD camera signal transmission transformers/filters.

New energy electric vehicle DC bus special nanocrystalline magnetic core, customized EMC oval amorphous nanocrystalline magnetic core, frequency converter EMI magnetic core

The elliptic nanocrystalline core is mainly used for common-mode filter inductance, which is convenient to pass through the bus directly. It is mainly used between frequency converter and motor to filter out high-frequency noise, so as to protect frequency converter and motor bearings. It is widely used in power assembly of new energy electric vehicles and charging stations.

Nanocrystalline magnetic strips

Nanocrystalline block core, nanocrystalline block is made of 25 micron thick nanocrystalline strip, nanocrystalline block has the characteristics of low core loss, high permeability, suitable for high-frequency transformers, inductors, sensors, wind turbines.

Nanocrystalline C core

Nanocrystalline C core, amorphous c core upgrade products, with high saturation flux density, low coercivity, low core loss, very low noise, high frequency up to 20KHz, suitable for main transformer, output inductance, boost PFC choke. It can replace ferrite core. The size can be customized.

Amorphous nanocrystalline cutting and air gap core

Amorphous and nanocrystalline gap magnetic core, suitable for large current output inductors, PFC choke, differential mode choke, Hall effect sensor concentrator, with high saturation flux density, low core loss advantages. Low cost replacement of high core.

Nanocrystalline rectangular magnetic cores for high power transformers